---

• Please refer to the attached document "Process to update the Digital Snake unit" (S-0808_v1003_e01.pdf) for more information such as the update procedure.

 

---

Checking the version number

1. Turn on power of S-0808.
2. Boot up S-4000 RCS.
3. Select serial port where S-0808 is connected on serial port selection window of S-4000 RCS.
4. Click [Info] button on S-4000 RCS. The Device Info dialog like below will be displayed.
   * If you find the version number is the latest one, update process is not necessary.

 

---

Update history
[ Ver.1.003 ]
The following bug is fixed.

• When holding the "MUTE ALL OUTPUTS" button and unplugging a REAC cable, noise might occur on the OUTPUT signal.

 

---

What you will need to update your S-0808
The following products/devices are necessary to carry out the update process.

• S-0808 unit
• REAC Embedded Power source unit (S-4000D/S-4000M) or an external battery.
• S-4000 RCS software (Ver. 2.0 or later)
• Windows PC equipped with serial (RS-232C) port and can run S-4000 RCS software properly.
• Serial cable (The remote cable contained as part of S-4000R accessory or ordinary sold RS-232C cable : D-Sub 9pins, male-female, straight type)

 

---

Caution when performing the update

• Never apply this update data to any product other than the S-0808. This update data may destroy the data or system program of other products.
• Never power-off your S-0808 while the update is in progress!
  If a power failure or similar accident occurs during the update process, the S-0808 won’t be able to start up in normal operating mode. This will require servicing, so you will need to contact Roland service center near you if this occurs.
• We regret that we are unable to answer questions regarding the update procedure using this system program. Please perform the update responsibly, following the directions given in this document.

 

---

Getting the update file  

---